No products in the cart.

E40 to CDM Adapter

E40 to CDM Adapter

£10.00

This E40 to CDM Adapter converts your current reflectors E40 lamp fitting for use with a CDM lamp. CDM lamps give you incredible full spectrum light which gives much better quality than you would expect from HPS lighting alone.

E40 to CDM Adapter

£10.00

- +
DESCRIPTION
HOW TO USE
Convert with this E40 to CDM Adapter to get more yield per watt than HPS!
  • Save on your electricity bills and produce the same yields!
  • CDM - full spectrum light output that plants love
  • Less heat output than equivalent HPS lights
  • Gives off 1.9 ╬╝mol PPF per watt - amazingly efficient!
Contains

1 x E40 to CDM Adapter / Converter

How the E40 to CDM Converter / Adapter Works

The E40 to CDM Adapter simply screws into your reflector's E40 lamp fitting, this then lets you use CDM lamps alongside a specific CDM Ballast.

 

 

How to use the E40 to CDM Converter / Adapter

PLEASE NOTE: The 315w CDM lamps need to be bedded in as follows: on first illumination, the lamp needs to be run continuously for a minimum of 15 minutes. This will allow the metals within the lamp to fuse correctly.

FAILURE TO DO THIS WILL RESULT IN LAMP DAMAGE!
If the above is not adhered to, lamp warranty claims will be void.

If the above is not adhered to, lamp warranty claims will be void.

Simply screw the convertor into your current reflector E40 fitting and screw the CDM lamp into the convertor in your reflector as tightly as possible by gripping the lamp with a clean, dry cloth. If the lamp is not screwed in as tightly as possible, arcing can occur between the center contact of the lamp and the lamp holder. This melts the solder contact on the bottom of the lamp, causing damage and making it unusable. Make sure that the lamp is clean and completely free of fingerprints and other contaminants. Finally, make sure that your reflector is hung at the correct height for your CDM Lamp.

The wattage of your ballast MUST match the wattage of the lamp you are using or there will be a high risk of fires or equipment damage.

Never use an HPS or MH ballast with CDM lamps. Connect the mains plug to an electrical outlet socket and switch it on. The CDM ballast will start up and light the lamp.

Please note: With CDM lamps until they have achieved at least 10 hours of use (from new) they should not be switched off for at least 2 minutes after switch-on. This includes testing during the initial installation. If it happens then the light needs to be left off for at least 1 hour before switching back on again. Failure to do this will damage the lamp and will lead to ignition problems.

TOP SELLERS

Explore our top picks for stellar yields! Our best-sellers range from spacious grow tents and efficient LED grow lights to premium hydroponic nutrients and plant propagation must-haves. We have everything you need, no matter what you dream of growing!
usercartcrossmenuchevron-down
0
    0
    Your Cart
    Your cart is emptyReturn to Shop
      Apply Coupon
      Available Coupons
      bbhydro10 Get 10% off
      luza Get 12% off